Факультет електроніки та інформаційних технологій (ЕлІТ)
Permanent URI for this communityhttps://devessuir.sumdu.edu.ua/handle/123456789/20
Browse
232 results
Search Results
Item Effect of Different Selenium Precursors on Structural Characteristics and Chemical Composition of Cu2ZnSnSe4 Nanocrystals(Institute of Physics Polish Academy of Sciences, 2022) Кахерський, Станіслав Ігорович; Кахерський, Станислав Игоревич; Kakherskyi, Stanislav Ihorovych; Pshenychnyi, R.; Доброжан, Олександр Анатолійович; Доброжан, Александр Анатольевич; Dobrozhan, Oleksandr Anatoliiovych; Vaziev, J.; Опанасюк, Анатолій Сергійович; Опанасюк, Анатолий Сергеевич; Opanasiuk, Anatolii Serhiiovych; Gnatenko, Y.In this work, Cu2ZnSnSe4 nanocrystals were synthesized by the polyol method. The chemical composition and morphological, structural, and microstructural properties of Cu2ZnSnSe4 nanocrystals, depending on the synthesis temperature and time, as well as the composition of the precursor, have been thoroughly investigated using scanning and transmission electron microscopy, energy dispersive X-ray analysis, X-ray diffraction, FTIR spectroscopy, Raman spectrometry, and low-temperature photoluminescence. We compared the properties of nanocrystals synthesized from different precursors containing selenourea or amorphous selenium as a source of selenium and then determined the optimal conditions for the synthesis of nanocrystals. It was found that the optimal synthesis time for nanocrystals obtained in the first approach is τ = 30–45 min, and in the second approach — τ = 120 min. It was also found that the optimal composition for the synthesis of single-phase Cu2ZnSnSe4 nanocrystals in the second approach is the molar ratio of precursors 2:1.5:1:4, and the synthesis temperature T = 280◦C. Thus, Cu2ZnSnSe4 nanocrystals synthesized under optimal conditions are used to develop nanoinks for printing solar cell absorbers by two- and three-dimensional printers.Item Structural and Optical Properties of CuO Thin Films Synthesized Using Spray Pyrolysis Method(MDPI, 2021) Д'яченко, Олексій Вікторович; Дьяченко, Алексей Викторович; Diachenko, Oleksii Viktorovych; Kováˇc, Jr.; Доброжан, Олександр Анатолійович; Доброжан, Александр Анатольевич; Dobrozhan, Oleksandr Anatoliiovych; Novák, P.; Kováˇc, J.; Skriniarova, J.; Опанасюк, Анатолій Сергійович; Опанасюк, Анатолий Сергеевич; Opanasiuk, Anatolii SerhiiovychCopper oxide thin films were obtained using pulsating spray pyrolysis method. The morphological, structural, and optical properties of fabricated films were studied. X-ray analysis revealed that the CuO thin films are single-phase. The study of films morphology by SEM and AFM methods showed that the obtained films have a fairly high surface roughness and contain grains of different shapes and sizes. It was found that the obtained films of copper oxide have high values of the absorption coefficient, which confirms the possibility of their use as absorbing layers for solar cells. The obtained values of the optical band gap of the material are in the range from 1.45 eV to 1.60 eV. Raman spectroscopy revealed three modes A1g, B1g, and B2g, of the crystal structure of monoclinic CuO. The devices based on p-type copper oxide are promising for solar cells fabrication because they can reduce production costs, due to their low cost and inexpensive production methods compared to silicon solar cells fabrication.Item Infuence of the thermal annealing on the morphological and structural propertie(Springer Nature, 2020) Доброжан, Олександр Анатолійович; Доброжан, Александр Анатольевич; Dobrozhan, Oleksandr Anatoliiovych; Пшеничний, Роман Миколайович; Пшеничный, Роман Николаевич; Pshenychnyi, Roman Mykolaiovych; Vorobiov, S.; Курбатов, Денис Ігорович; Курбатов, Денис Игоревич; Kurbatov, Denys Ihorovych; Komanicky, V.; Опанасюк, Анатолій Сергійович; Опанасюк, Анатолий Сергеевич; Opanasiuk, Anatolii SerhiiovychIn this work, ZnO flms were deposited onto fexible polyimide substrates by ink-jet printing nanoinks containing polyolsynthesized nanocrystals. ZnO flms were annealed at 200–400 °C for 10 min and 60 min under the ambient atmosphere. The morphological (shape, size, size distribution, surface roughness), structural (phase composition, crystal structure), optical (band gap, transmission coefcients) properties and the chemical composition of the synthesized nanocrystals and the obtained flms were studied. X-ray difraction analysis, transmission and scanning electron microscopies, atomic force microscopy, Fourier-transform infrared (FTIR) and optical spectroscopies, and energy-dispersive X-ray spectroscopy (EDS) were used to study the properties of obtained ZnO materials. The flms, annealed at Ta=400 °C for ta=60 min, and nanocrystals, synthesized for tg=120 min, have the good fundamental characteristics for application in the microelectronic devices, especially in solar cells and thermoelectric generators.Item The effect of low-temperature annealing treatments on the structure and chemical composition of CU2ZNSNS4 films deposited onto flexible polyimide substrates(Ivan Franko National University of Lviv, 2020) Доброжан, Олександр Анатолійович; Доброжан, Александр Анатольевич; Dobrozhan, Oleksandr Anatoliiovych; Кахерський, Станіслав Ігорович; Кахерский, Станислав Игоревич; Kakherskyi, Stanislav Igorevich; Опанасюк, Анатолій Сергійович; Опанасюк, Анатолий Сергеевич; Opanasiuk, Anatolii SerhiiovychItem Газочутливий елемент детектора, створений методом друку з використанням наночорнил Ag та ZnO(Сумський державний університет, 2020) Гузенко, Олександр Ігорович; Гузенко, Александр Игоревич; Huzenko, Oleksandr Ihorovych; Кахерський, Станіслав Ігорович; Кахерский, Станислав Игоревич; Kakherskyi, Stanislav Igorevich; Доброжан, Олександр Анатолійович; Доброжан, Александр Анатольевич; Dobrozhan, Oleksandr Anatoliiovych; Опанасюк, Анатолій Сергійович; Опанасюк, Анатолий Сергеевич; Opanasiuk, Anatolii SerhiiovychItem Вплив складу сполуки CZTSSe на величину оптичних втрат у сонячних елементах на основі гетеропереходів n-ITO(ZnO)/nCdS/p-CZTSSe(Сумський державний університет, 2020) Волобуєв, В.В.; Кахерьский, Станіслав Ігорович; Кахерский, Станислав Игоревич; Kakherskyi, Stanislav Igorevich; Доброжан, Олександр Анатолійович; Доброжан, Александр Анатольевич; Dobrozhan, Oleksandr Anatoliiovych; Опанасюк, Анатолій Сергійович; Опанасюк, Анатолий Сергеевич; Opanasiuk, Anatolii SerhiiovychItem Синтез наночастинок сполук CZTS, CZTSе для створення чорнил для друку гнучкої електроніки(Сумський державний університет, 2020) Шаповалов, О.І.; Кахерcкий, Станіслав Ігорович; Кахерский, Станислав Игоревич; Kakherskyi, Stanislav Igorevich; Пшеничний, Роман Миколайович; Пшеничный, Роман Николаевич; Pshenychnyi, Roman Mykolaiovych; Опанасюк, Анатолій Сергійович; Опанасюк, Анатолий Сергеевич; Opanasiuk, Anatolii SerhiiovychItem Раманівська спектроскопія наночастинок CZTS, одержаних методом поліольного синтезу(Сумський державний університет, 2020) Гаврилюк, Є.О.; Кахерський, Станіслав Ігорович; Кахерский, Станислав Игоревич; Kakherskyi, Stanislav Igorevich; Доброжан, Олександр Анатолійович; Доброжан, Александр Анатольевич; Dobrozhan, Oleksandr Anatoliiovych; Пшеничний, Роман Миколайович; Пшеничный, Роман Николаевич; Pshenychnyi, Roman Mykolaiovych; Опанасюк, Анатолій Сергійович; Опанасюк, Анатолий Сергеевич; Opanasiuk, Anatolii SerhiiovychItem Cтруктурні та субструктурні характеристики нанокристалів і плівок ZnO для використання у сонячній енергетиці(Дніпровський національний університет імені Олеся Гончара, 2020) Доброжан, Олександр Анатолійович; Доброжан, Александр Анатольевич; Dobrozhan, Oleksandr Anatoliiovych; Кахерський, Станіслав Ігорович; Кахерский, Станислав Игорович; Kakherskyi, Stanislav Ігорович; Пшеничний, Роман Миколайович; Пшеничный, Роман Николаевич; Pshenychnyi, Roman Mykolaiovych; Опанасюк, Анатолій Сергійович; Опанасюк, Анатолий Сергеевич; Opanasiuk, Anatolii SerhiiovychItem Raman Characterisation of Cd1−xZnx Te Thick Polycrystalline Films Obtained by the Close-Spaced Sublimation(Institute of Physics of the Polish Academy of Sciences, 2017) Знаменщиков, Ярослав Володимирович; Знаменщиков, Ярослав Владимирович; Znamenshchykov, Yaroslav Volodymyrovych; Косяк, Володимир Володимирович; Косяк, Владимир Владимирович; Kosiak, Volodymyr Volodymyrovych; Опанасюк, Анатолій Сергійович; Опанасюк, Анатолий Сергеевич; Opanasiuk, Anatolii Serhiiovych; Дорда, Віталій Олександрович; Дорда, Виталий Александрович; Dorda, Vitalii Oleksandrovych; Fochuk, P.M.; Medvids, A.In this work, we studied the Raman spectra of thick polycrystalline Cd1-xZnx Te (CZT) films with x ranged from 0.06 to 0.68. Additionally, the surface morphology and structural properties were studied in order to determine the crystalline quality of the samples. The Raman spectra had a two-mode behavior typical for CZT solid solution and showed CdTe- and ZnTe-like longitudinal and transverse optical modes. The relationship between the frequencies of CdTe- and ZnTe-related modes on x was studied. We observed the deviation of the compositional dependence of phonon mode frequencies for polycrystalline CZT films in comparison with a similar dependence for CZT single crystals. Such deviation was caused by the effect of structural defects in polycrystalline films on frequencies of vibrational modes. The values of excitation wavelength, which allow achieving of high signal-to-noise ratio on the Raman spectra of CZT films with different zinc concentration in the result of resonant enhancement of phonon modes intensities, were experimentally determined.